How to Fix iProg+ Clone if RFID and UART Not Working?

Here’s the customer solution to v84 iprog+ pro clone programmer RFID and UART/BDM adapters not working, only eeprom adapter working problem.

You are at your risk.

Fix Iprog Clone 1

Fix Iprog Clone 2

Fix Iprog Clone 3

How to fix iprog pro?

Fix Iprog Clone 4

Fix Iprog Clone 5

Remove case of iprog

Check GND PIN case

Fix Iprog Clone 7

Fix Iprog Clone 8

 

This pin give -12v output and it must be 5V

Fix Iprog Clone 9

Fix Iprog Clone 10

This pin give 11.5V output. Must be 12V output.

Fix Iprog Clone 11

Remove the upper power board of iprog

Fix Iprog Clone 12

Testing the power board and it work fine

Fix Iprog Clone 13

Removing the eboxy by hotair and sculpt tool

Fix Iprog Clone 14

Fix Iprog Clone 15

found the problem in the resistor (marked red arrow), change it with 4.7k Ω

Fix Iprog Clone 16

finally iprog+ work fine with all adapters.

Done.

sales