This guide explains how to connect the Launch LX CAN gateway cable and use Launch X431 diagnostic scanners to perform diagnostics on 2022 and newer Li Auto models.
Supported Li auto models:
LX CAN Diagnostic Cable 1 (94PIN)
Applicable for Li Auto L7, L8, L9 models produced before 2024.
LX CAN Diagnostic Cable 2 (40PIN)
Applicable for Li Auto L6, L7, L8, L9 models produced in and after 2024.
Compatible devices:
Launch X431 EV scanner (CRP919 EV, X431 Pro3S+ EV/ Pro3s+ EV V2) or passenger car diagnostic scanner with EV kit (add-on module).

Instructions:
Step 1: Turn off high-voltage system and low-voltage system
Open the front hood, remove the front cover.
Find this connector, pry open the white buckle below.
At the time, the high-voltage system is powered off.


Go to car’s infotainment system.
Select vehicle- Maintenance- selecy vehicle power. Turn off the power.
Open the trunk.
Remove the upper guard plate.
Take out the accessory box.
Loosen the negative terminal of the battery。
Remove the negative terminal。
At thie time, the low-voltyage system is powered off.

Step 2: Connect the Launch LX CAN Cable
Connect Launch X431 Li gateway cable with SGW module and VCI.
Remove 4 screws that fix the passenger seat.
Turn the seat over.
Lift the carpet underneath.
You will see the gateway module.

We suggest unscrew the 4 screws that fix the gatwaye module as well.
Now disconnect the security gateway module with the original vehicle network connector (blue).
Then connect the X431 Li cable blue end with the gateway connector.
Fasten the pressure buckle above the Li cable connector.
Connect another end of the X431 Li cable to the original vehicles’s network interface.

Connect OBD CON1 connector with Smartlink VCI.
Launch Li cable OBD CON1 and OBD CON2 connectors support different modules.


Connect Smartlink VCI with X431 tablet.
Step 3: Start diagnosis.
After connecting the Launch Li cable, start diagnose Li model with X431 EV scanner.
Update the EV software to V10.50 and above.
OBD CON1 cable will detect some modules.
Disconnect OBD CAN1 cable, then connect OBD CON2 cable, it allows scan some other modules.

Step 4:
Disconnect Launch Li cable if finish diagnosis.
Connect the nagetive pale of lower voltage battery.

Go to front hood, find this connector. Push the white clip back in place.




















