Is it possible to clone 4A chip using Autel AT100 super chip?
Autel’s latest update enables 4A chip cloning.
Example: clone Hyundai/Kia 4A chip with Autel KM100 using AT100.
Procedure:
Read original key information.
It’s a Hitag AES ID4A smart key.

Press Clone button to enter the cloning process.
Select 4A Transponder Cloning.

Press Start to begin identifying the original key.
Place the KM100 device close to the ignition coil to acquire data.
Turn on the ignition with the original key. For a smart key, remove the battery. Then turn the ignition on and off repeatedly until the prompt for data acquisition success appears.
After the data acquisition succeeds, place the original key in the key slot of the KM100 and press Next to begin authenticating the original key.
The IMMO SK and PIN Code is successfully calculated.

Press OK to process.
The calculation has been performed successfully.

Place the original key in the key slot and press OK to read its information.
After reading is successful, remove the original key and place the AT100 super transponder chip into KM100 coil.
Clone AT100 chip successfully.

After the cloning succeeds, the AT100 transponder can be used for emergency starting.






















