In this article, we walk through the process of reading and cloning a BMW 528i petrol MSV90 DME ECU using the OBDSTAR ECU Master.
The problem: the board is completely burnt — damaged on multiple sides. The customer needs the data backed up so it can be transferred to a replacement ECU or used for repair.
Because the ECU is badly damaged, there are no useful identifying labels (no EDC or similar markings visible). However, the unit is confirmed to be an MSV90.
Identifying the ECU in OBDSTAR ECU Master
In the OBDSTAR ECU Master software:
- Use the search bar
- Type MSV90
- Select the result: BMW Continental
- Go to the Pinout section
- Select Bench Mode
The part number shown matches the ECU being worked on — both are the same part number.
Bench Mode Connections
The connector picture and pinout are used to wire the ECU. All connections are made to the OBDSTAR ECU Master for bench mode operation.
Key detail: the ECU is heavily burnt — most of the board is damaged. The processor is also shown for reference:
- Processor number: 1796
- This is a TriCore processor
Despite the damage, the tool attempts to connect and read the ECU.
Connecting and Reading
The ECU Master is started in Bench Mode and the connection is initiated. The tool checks whether it can read the ECU.
The ECU connects successfully — even with the extensive burn damage.
The flash file can be read directly.
Reading the ISN Code
The ISN code is needed for any replacement or cloning work. The tool reads it:
The ISN code number is retrieved successfully.
This code is now available for writing to a replacement ECU if needed.
Reading All Data / Flash
To back up the ECU data, the read process is started:
Read from is selected
The reading sector starts
The EEPROM is read successfully
The file is saved.
Read Internal is pressed — this also reads successfully (already done earlier as well)
Why This Backup Matters
The backup is being taken so that:
- The data can be preserved in case the ECU cannot be repaired
- The data can be written to a replacement ECU if needed
Other Functions Available
The ECU Master offers many other functions for this ECU, including:
Read All Data
Write All Data
These were already performed earlier. The ECU is connected successfully.
Hardware and Part Number
The ECU hardware is shown again for reference, along with its part number. Even though the board is badly burnt, the tool was able to connect and read the data.
Completion
The work with the OBDSTAR ECU Master is now complete:
- ISN code read successfully
- EEPROM read and backed up
- Internal flash read and backed up
- All data functions available and tested
- The ECU connected and communicated despite severe burn damage
The data is now backed up and ready for use in cloning or replacing the damaged MSV90 DME.
Summary
This case demonstrates the capability of the OBDSTAR ECU Master to read and back up a BMW MSV90 DME even when the ECU board is severely burnt.




















