How to Use Autel VCI200 with Toyota Techstream V18?

How do I connect the Autel VCI200 interface with Toyota Techstream software? We are going to use the MaxiVCI V200 interface, which comes with the Autel KM100 key programmer.

The VCI200 can be configured as J2534. If you are afraid of damaging the device during such a test, you can get a separate VCI200 dongle. It works with multiple passthru software Clip, Vida, ODIS, Xentry, Techstream etc.  Here we tested it with Techstream 18.00.008. Search our blog to download software for free.

OpenPort does not have access to the MS CAN on Ford, Jaguar & Mazda used in many of their models, the Autel VCI200 without problems.

 

How to set up V200 with Techstream?

Download and install maxi pc suite driver on your laptop.
Connect v200 with laptop,  it recognizes the interface then if it is correct. You have to update the interface hardware.  Update the firmware you can still use with KM100.

Have the interface ready to connect. Have the switch on.
Then make the connection. It is already connected.

Autel Vci200 With Toyota Techstream 5

Autel Vci200 With Toyota Techstream 1

Choose VCI as V200.

Autel Vci200 With Toyota Techstream 2

Autel Vci200 With Toyota Techstream 3
Select vehicle and model. It is a 2016 Toyota Corolla.

Autel Vci200 With Toyota Techstream 6
It is possible to see different modules.
You see the VCI200 indicator turns green. It is already making the connection.
It automatically detected two fault codes.

Autel Vci200 With Toyota Techstream 7

Autel Vci200 With Toyota Techstream 8

 

See also:

How to Use Autel VCI200 J2534 Passthru with Ford FDRS?

OBDII365