Problem:
Tried to boot glitch unlock a VAG MD1CS004 H80 ECU with Korhex. Flex reads ECU ID, but nothing happens. Flex software is stuck on the glitch progress page. Any solution?
Solution:
Sometime you need to move korhex.
Move Korhex until you find the right spot!
If not working, abort operation.
If its over glitching.
Turn everything off.
Unplug everything.
Even pins.
Start again.
Allow program to boot and make sure you have 3 green or 2 green and one blue light on top left.
If needs update, update flex.
Then reconnect everything.
Place korhex central to plate.
Wabble plate in a square If it touches edge nudge it central
Make sure your e1 connector is on or off in manual on flex and follow instructions.
If it doesn’t read or connect email support on ticket.
