This is a BMW MSV80 Computer Siemens VDO. It is pretty much simple to be done with the new CG FC200 ecu programmer.
Once hit BMW, all series all will be here
On the top you just out msv80 and hit search
Search msv80 and the type ECUs type come up
You go to platform and check the wiring diagram
You tap twice the wiring diagram you see the hand color that then you could just move it around
You can also hit the zoom button and you can see it zooming
the wiring diagram shows both boot and regular mode
You can also read MSV80 in boot. Here is the boot pinout
I have everything hooked up. CG FC200 comes with these pins, these pins that make it very easy.
You don’t have to keep trying to stick something in a hole.
You get a bunch of pins and each pins got its different sizes to fit on these pins.
And I go into identification
Now the program is going to read the ecu
After read ecu, I hit read isn
It is going to read the vin and isn
So you have the VIN up here, then you have the isn right here.
It is pretty much easy and straightforward. It does not take long, just 3 minutes to hook it up and read.
