Sid208 PSA Boxer Egr off read-write with Foxflash or KT200 ecu programmer. It is very good. First step you need to read password then you can read and write.
Procedure to follow with foxflash.
-Read password in obd (follow instruction foxflash)
-Disassemble the vehicle’s ecu
-Open up the ecu
-Follow the pinout instructions provided by foxflash
-Id ecu
-Read the ecu
-Modify data
-Write the echo
It’s 100% working.
SIEMENS CONTINENTAL SID208 [ TC1797 INT.F.] – Peugeot, Citroen Instructions
Step 1: Password Search
Connect the pinout below with multifunction cable.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Tool Password
→ OBD PASSWORD SID208 PSA
→ Click on “Find Password” and follow the software messages.
Attention: On some SID208 PSA you can find the password only via OBD
Now that the password has been found it’s possible to read and write the control unit.
Step 2: Read and Write ECU
Connect with the multifunction cable the following
pinout and the boot shown below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1797
Example 1:
sid208 psa (peugeot boxer 2,2hdi 2016) 100% working in boot with foxflash.
Example 2:
Ford SID208 find password via OBD. But made pinout with MPPS cable to mimic OBD and read password fine. ECU is water damaged hence why doing it in boot mode.
Example 3:
KT200 in action
computer protected by a password needed for reading and writing your name is fap egr.
