How to Repair BMW E90 2011 FRM Module by Launch X431 Pro

Many BMWs have a Foot Well Module or FRM that controls electrical functions such lighting.
Location:
This is the module that sits on the drivers side foot well, behind the hood release (in US cars).

 

Which vehicles are affected?
E90 Series BMW 3 Series Cars
E70 X5 Series
E81,E82,E87,E88 1 Series
What Faults are covered?
Various faults including
Reversing Lights Not Working
Number Plate Lights Not Working
1 or more sidelight,headlight,brake or tail lights not working

 

 

What causes these problems?
The FRM Footwell Module monitors & detects short circuit’s either in the wiring (common in the
E90 boot area) or a short circuit bulb. If you do not get the fault repaired quickly then the module
will eventually permanently switch off that particular output. Once it’s switched off it doesn’t make
any difference if you have repaired the fault the light will stay off.

 

BMW mechanic replace the complete FRM module at a cost of several hundred pounds including coding the module to your car. Here is the procedure in action on a reset we did to a E90 recently.

 

Solution:
Load/re-write the original eeprom dump (parts requires coding as well)
Vehicle model example:
2011 BMW 3-series E90

 

Read FRM module CPU data with VVDI Prog, Xprog or CG100 ecu programmer. Follow the wiring diagram and read eeprom data.
CPU type 9S12XEQ384

bmw-e90-2011-frm-module

fix-bmw-e90-2011-frm-module-1

You can see all data shows F, blank data, CPU data may has been lost

fix-bmw-e90-2011-frm-module-2
Load the original eeprom dump and re-write to CPU.

 

 

When do you need coding/don’t need coding?
There are many variants of FRM (Footwell Module) FRM1, FRM2, and FRM3 which all have different controls and functions such as lights, windows and doors. If the eeprom data is exactly the same as your car original data, you do not need coding.  If fog light or aperture still flashes after load original data, you need to do coding.

 

Device optional:

BMW ICOM Engineering software Ncs expert, Launch X431 V pro, Autel Maxisys Pro MS908P etc

 

 

Here is the instruction of Launch X431 Pro, it is easier than ICOM engineering software.

Select vehicle make: BMW
Select Coding/Programming

fix-bmw-e90-2011-frm-module-3

Select detail model: 3 series E90

fix-bmw-e90-2011-frm-module-4
Select data stream: FRM Module has been replaced

fix-bmw-e90-2011-frm-module-5

Select FRM module

fix-bmw-e90-2011-frm-module-6

Download file

fix-bmw-e90-2011-frm-module-7

Flash/Reset FRM

fix-bmw-e90-2011-frm-module-8

Complete

fix-bmw-e90-2011-frm-module-9

FRM module is repaired.

 

Related Post:

Xprog and Ncs Expert recover FRM on BMW E84

Ncs expert WinkFP read write reset update FRM

Xprog WinKFP fix dead FRM3 on BMW R56

sales