Astra-H DPF Regeneration with OPCOM V1.45

Here is the instruction on how to perform Astra-H DPF Regeneration with op-com diagnostic interface.

 

Car Model: Astra H Z19DT

Tool:

Op-com cable (i using firmware V1.45)
OPCOM software (2012V)
USB cable
A clean Win XP Laptop

Warning:

Before you try out this procedure, please notice that the exhaust gas temperature will increase to over 600°C, so you must perform this outside, on a non-flammable ground. Also to avoid consequential damages, the DPF regeneration must be executed only once!

Disclaimer

This regeneration, if carried out is of responsibility of those carrying it out.

Procedure

Install opcom software on the laptop.
Turn on the ignition key and make sure the engine is running at idle and fully warmed up.
Hook up opcom cable to the car and the laptop.
Fire up the software.
Go to GM based Saab, select Astra H with DPF when prompted.
Select “Particulate Filter Regeneration” in the next window.
Click “Start Regeneration” to start the regeneration.

opcom-software-1-600x417

opcom-software-2-600x415

Once the Regeneration is done, live data “Diesel Particulate FilterSaturation” will be changed change. When engine controller has performed, a dynamic regeneration value will be changed.

 

Some more info:

This modification can also work on the following models:

Astra-H

Z19DTH, Z19DTL, Z17DTR, Z17DTJ

Zafira B

Z19DT, Z19DTH, Z19DTL, Z17DTR, Z17DTJ

Vectra-C / Signum

Z19DT, Z19DTH, Z19DTL

Corsa-D

Z13DTH, Z17DTR

Antara

2.0LDiesel engine

www.obdii365.com

OBDII365