Tips to Repair Ford Airbag R7F7010643 (Encrypted) with CG100X

Here is the tip for repairing these encrypted Renesas R7F7010643 Ford airbags using CG100X programmer.

Model example:

Ford Focus 2023

Restraint control module Part number: RJ7T 14B3 21 AB
Processor: Renesas R7F7010643 encrypted

Cg100x Repair Ford Airbag R7F7010643 1

Step 1: Diagnose airbag module

First we read the SRS fault code with CG70 airbag reset tool or a diagnostic scanner.

Run CG70 software, go to Ford and select the corresponding part number. It will show you the wiring diagram.

Cg100x Repair Ford Airbag R7F7010643 2

Connect the airbag module with CG70.

Cg100x Repair Ford Airbag R7F7010643 3

Read fault code. If you get a code B1193 Crash event storage full and locked, this means the vehicle was in an accident and it has crash data stored in the ACM/SDM airbag control module. This code will not clear and won’t erase with any diagnostic scan tool. It will give you the error “cannot execute routine”.

Cg100x Repair Ford Airbag R7F7010643 4

We can erase the crash data using CG100X.

 

 

Step 2: Repair Airbag with CG100X

The processor is encrypted, it cannot be handled with cg70, you need cg100x. P50 from OBDSTAR can diag only, it cannot erase crash on this airbag. CG100X does.

CG100X will decrypt and read data of this mcu.

Run CG100X software, select Ford and search part number. It will show you the wiring diagram.

Cg100x Repair Ford Airbag R7F7010643 5

Zoom in and watch the wiring carefully.

Cg100x Repair Ford Airbag R7F7010643 6

Require the removal of 1 capacitor on the main board.
Also required to use D1 adapter, 2mm thin cable and a 5.10 resistor.

The capacitor is tiny. Be careful when desoldering the capacity.

Cg100x Repair Ford Airbag R7F7010643 7

Then connect SRS module with CG100X, D1 adapter.

Cg100x Repair Ford Airbag R7F7010643 8

Do not let the 5.10 resistor touch the board, as this may cause a short circuit or a lack of communication.

After setting up the connection, start to decrypt chip.

Then read chip (Dflash and Pflash) and save data.

Cg100x Repair Ford Airbag R7F7010643 9

Press Yes to repair airbag data.

Cg100x Repair Ford Airbag R7F7010643 10

Writing chip.

Erase airbag crash successfully. The srs module is repaired.

Cg100x Repair Ford Airbag R7F7010643 11

Disconnect wires with cg100x.

Don’t forget to solder that capacitor back to the airbag main board.

 

 

Step 3: Read fault code again

Connect airbag with cg70 again. Read fault code and make sure there is no crash fault code stored.

 

 

Read also:

Tips to Clear Chevrolet Aribag R7F7010643 Crash with OBDSTAR P50

OBDII365