Hundreds of car remote keys can be unlocked by CGPro 9S12 programmer. Here is an example of BMW F series CAS4 remote.
CGDI BMW detected this used remote as Unlocked.
Remove key shell and battery, check frequency 434MHz and type HUF5767, take a screenshot of this info.
Check chip type: 28PIN, PCF7953
Run CGPro software, select Brand-Key Renew-BMW F series- Huf–F series 434MHz
*Select Huf-F series 434 Mhz if cannot find PCF7953 434MHz. This has been verified working.
CG Pro will show you the wiring diagram
1-VBAT
12-VSS
6-P10 MSCL
7-P11 MSDA
*Follow wiring diagram above if it is the same as the image above, otherwise, solder point using a multimeter.
Connect key board with CGPro via eeprom adapter
check connection again, in CG-Pro software, press Renew icon, cgpro starts unlocking remote until finished
Disconnect wiring, reinstall the battery and key shell.
Check remote status, it is unlocked.
Done.
