How to Configure WiFi Connection for Original JLR DoIP VCI

Original Jaguar Land Rover diagnostic tool JLR DoIP VCI supports both USB and WiFi connection. Here’s the guide to configure the LAN setting.

wifi-jlr-doip-vci

Procedure:

Connect JLR DoIP VCI W-F interface with vehicle

Connect the other end of VCI with laptop via USB cable

jlr-doip-vci-sdd-1

Open VCI Manager (JLR), press Connect

jlr-doip-vci-sdd-2

Choose Network Setup tab->Wired Etherent

jlr-doip-vci-sdd-3
Tick Enable Wired Etherent Interface

jlr-doip-vci-sdd-4

Press Apply button and Yes

jlr-doip-vci-sdd-5

Then disconnect USB connection

Close VCI Manager

 

Open VCI Manager again

Press Connect

Go to Network Setup->Wired Etherent

Press Set Factory Default

jlr-doip-vci-sdd-6

Press OK if system prompts you are about to reset the VCI communication settings to a factory default state.

jlr-doip-vci-sdd-7

Enable network connection

Press Set Factory Default again

jlr-doip-vci-sdd-8

In Wireless (802.11), choose Obtain an IP address automatically, then press Access Point

jlr-doip-vci-sdd-9

Choose Wireless resource which is the same as the your network
Press Configure

jlr-doip-vci-sdd-10

Enter wireless security password (encryption key)

Press Next

jlr-doip-vci-sdd-11

JLR VCI is configured to connect to your network

Disconnect and then Connect VCI

jlr-doip-vci-sdd-12

It shows WiFi connection is done

 

Open JLR SDD software on desktop

jlr-doip-vci-sdd-13

Press Connect

jlr-doip-vci-sdd-14

Now you can run SDD software for diagnosis

jlr-doip-vci-sdd-15

jlr-doip-vci-sdd-16

jlr-doip-vci-sdd-17

jlr-doip-vci-sdd-18

www.obdii365.com

sales