Ktag ksuite 6.070 read Audi A6 ME7.5 successfully

Found some had trouble in reading ME7 by his ECU device. Here is my experience of reading ME7.5 with my ECU tool KTAG master. Hope it would helps.

 

My KTAG ksuite firmware 6.070 ecu programmer source:

http://www.obdii365.com/wholesale/ktag-ecu-programming-with-new-hardware.html

 

i just tried to read ME7.5 with K-tag, everything good !

ME7 boot pin

ktag-ME7-boot-pin

ME7 pin out

ktag-ME7-pin-out

Pin 3,62 – red – +12V

Pin 2 – black – ground

Pin 43 – yellow – K-Line

Soldered wire – gray with alligator clip – BOOT

 

ME7 Protocol selection

ktag-ME7-Protol-select

Select BOOTLOADER ST 10FXXX>>BOSCH ME7.5 VAG HW II

ME7.5 full files

ME7-ktag

ME7.5 full read

ktag-ME7

And i found there is problem with Ktag 6.070 while selecting cars family:

If i try to read with cars family, it won’t read;

But, if i select Protocol and get the correct family. it read perfectly well!

 

OBDII365