Here is another easier way to read Ford or JLR SID208 ECU using J2534 devices, pcmflash software and godiag adapters.
Device used here:
pcmflash software
Scanmatik pro 2 (or other J2534 devices, openport etc)
Godiag GT100+ breakout box (will work with or without this breakout box, but it is good to check communication)
Procedure:
Video reference:
Step 1: Read Password (via OBD on bench)
Connect j2534 with gt100 and godiag ecu adapter
Connect SID208 with godiag adapter via jumper cable follow the wiring diagram attached below
Power gt100 with 12v adapter
Connect pcmflash dongle with PC
NOTE: Must press the switch on Godiag ECU adapter to read ECU.
Run pcmflash software
Select 07 module JLR or Ford SID208 model
Read and Save password.
Step 2: Read and write ECU
Open ECU
Connect ECU with godiag ecu adapter according to the previous wiring diagram
Then solder the chip to the PCB board according to the wiring diagram
Directly connect the red wire to CNF1 on the PCB board
When complete connection, run pcmflash software
Select module 32 Infineon TC1797 EEPROM
Read and upload password read in step 1
Read and save eeprom
Select module 32 Infineon TC1797 MICRO flash
upload password again
Read and save flash data
Done.
If need to read SID208 with pcmflash in traditional way, check instructions here