Foxflash ecu programmer released new software update on May 23rd, 2023.
May 23, 2023 update
May can’t get any better as we release a new exclusive protocol today! In this update, you’ll find the BENCH protocol for Isuzu EDC17C83.
Supported Control Units & Vehicles
ECU:
Bosch EDC17C83 TC1793
Supported Vehicles:
Isuzu Dmax 2017-2022 1.9D 164cv
Isuzu Dmax Rodeo 2017-2022 1.9D 164cv
Isuzu M21 2017-2022 1.9D 123cv
BENCH read is real.
R/W time: ~6 minutes at first programming, then ~ 30s.
ATTENTION: Some of the latest vehicles might have a secure gateway.
Update method:
Run the foxFlash Manager software, and click the download button till all is done.
Foxflash bench pinout to BOSCH EDC17 C83 [ 1793 ] – Isuzu [Diesel]
To read and write use the following driver:
→ BENCH TRICORE
→ ISUZU
→ TC1793 – ISUZU
→ EDC17 C83
Foxflash Boot Mode Pinout to BOSCH EDC17 C83 [ TC1793 INT.F.] – Isuzu
Read and write ECU
Connect with the multifunction cable the following pinout and the boot shown below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1793
To connect to the sixth pin of the micro, we recommend the use of a Hook tweezer:
