BMW F10 Used TCM Programming with CGDI Prog BMW

Here’s the instruction on BMW F10 528i 2013 used TCM (EGS) programming after replacement.  Reset ISN with CGDI Prog BMW, tried flashing with E-sys but got some troubles, programming and encoding on car done by cgdi bmw and error check with ista+.

 

Part 1: Reset ISN on bench

Connect CGDI BMW with EGS 8HP (Check wiring diagram and detail guide here)

In CGDI BMW software, go to BMW EGS change8HP (F)Clear ISN

Bmw Tcu Replacement Cgdi 1

Confirm VIN

Bmw Tcu Replacement Cgdi 2
EGS ISN is cleared
that was the first part, done on bench.

 

Part 2:
The second part when trying to flash TCU, i got some troubles with e-sys, reported a PSD2 error.

Bmw Tcu Replacement Cgdi 3

Part 3: Programming TCU

Finally, i finish programming and encoding by cgdi bmw on car

Bmw Tcu Replacement Cgdi 4

Go to Diagnosis, Program and CodingBMW E/F Series Program

Bmw Tcu Replacement Cgdi 5

Select EGS SWFL desired to program, and press Advanced programming
CGDI will ask to keep car battery enough power and device cabled connected during the programming procedure

Bmw Tcu Replacement Cgdi 6

Bmw Tcu Replacement Cgdi 7
select file version and confirm
input 17-digit VINN and confirm

Bmw Tcu Replacement Cgdi 8
program ECU in progress

Bmw Tcu Replacement Cgdi 9

Program and flash tcu successfully.

check and erase fault codes with BMW ICOM ISTA+

Bmw Tcu Replacement Cgdi 10

Bmw Tcu Replacement Cgdi 12

Bmw Tcu Replacement Cgdi 13

OBDII365