Xhorse VVDI Pro Programmer read BMW 5 series N20 ECU

Newly arrival Xhorse VVDI-PROG programmer is able to read& write EEPROM, MCU and ECU for multi brand car models. Here is the instruction on reading BMW 5 series N20 ECU using VVDI Prog.
VVDI PRO reader BMW ECU
Open VVDI Pro software
Select type: 3-ECU
Select Brand: BMW E chassis
Select ECU type: MEVD1724 (N20)
VVDI PRO software
Select “Connection Diagram” button
The VVDI prog will prompt which adapter is going to use and display the detail ECU connection diagram
Follow the diagram to connect the adapter/cables with ECU
VVDI Pro Programmer read BMW 5 series N20 ECU VVDI Pro Programmer read BMW 5 series N20 ECU VVDI Pro Programmer read BMW 5 series N20 ECU

The position 1 cable is difficult to solder, so here use a conductive connection way
VVDI Pro Programmer read BMW 5 series N20 ECU
VVDI Pro Programmer read BMW 5 series N20 ECU
Check the diagram carefully and make sure all cables are connect correctly

Then connect VVDI Prog programmer with PC via USB cable
The VVDIPro indicator light flashes indicates that the communication is built
Click “New” tab
Click “Read” to read ECU data
Initializing, wait until it process to 100% (see progress on status bar at the bottom as well)
VVDI Pro Programmer read BMW 5 series N20 ECU
Read BWM ECU data completed
Save the data

Here is a VVDI Pro read BMW N20 ECU Chinese operation video guide for you to refer
https://www.youtube.com/watch?v=QqO5iA-Cy0Y

OBDII365