V2.11 KESS V2 FW V4.036 Unlimited Token Update and Installation

KESS V2 ECU tuning kit has newly released to latest software version V2.11 and firmware version V4.036 with unlimited token. Following displays the instructions on updating and installing Kess v2 programmer.

Operating system: Win XP (most) and WIN7

V2.11 KESS software can be installed on Win XP (most cases) and win7 system. But if your laptop has other OBD software which is not compatible with this software, please change the laptop or system to install. Better to use our Win XP O/S.

How to update old KESS V2 firmware V3.009 to V4.036?

To update old kess v2 tuning kit, you need to order the firmware update service Item No: SE87-CS. Then send back your KESS V2 main device to our factory.

NOTE:
Update service is valid for QC number ends with A015 only.

How to install V2.11 KESS V2 KSuite software?

Please disable local area connection and wireless network connection before installing software. Otherwise, the software would no work properly.

1) Install K-suite driver software
Update and Installation kess v2
Open K Suite-2.11 software CD
Unzip Ksuite zip. Patch to desktop

Open KSuite.exe setup on the folder
Click Next and then click Install the setup wizard
Click Yes to accept the Microsoft Visual C++ 2005 notice
Select software language, press OK

Click Next
Click Next Read Me file
Click Next to start install driver
Click Finish when complete install the Driver

Select KESS V2 software language
Click Ok to accept the system “Connection not established” message
Right click “K-Suite” on the desktop, click “properties”>> “Find Target”>> “help” and delete it
Paste to copy the folder “help” from E:\ to C:\
Update and Installation kess v2

2) Connect KESS V2

Connect the KESS V2 ECU programmer with vehicle and wait the system to find the hardware driver and install it

Click My Computer>>Manager>> Device Manager>> Universal Serial Bus controllers >> USB device to check and make sure there is good communication between KESS and computer.

3) Run KESS V2 KSuite V2.11 software

Open K-Suite on the desktop

It will automatically search software update online, firmware update online…read device info…Updating device…
Click vehicle icon
Select certain vehicle model, like BWM E90, press OK
Update and Installation kess v2
Accept warning notice by click OK
Select vehicle protocol: KLINE or CAN
Update and Installation kess v2
Select ID
Update and Installation kess v2
Click OK to accept warning
Switch on the dashboard, check the connections and press OK to continue
Turn ignition OFF
Click Ok to confirm software and firmware information
Create a new txt file “e90” on folder

4) Read ECU with KESS V2

Turn ignition OFF
Select Reading
Update and Installation kess v2
Turn ignition ON
Accept system notice to start reading the ECU
Turn ignition OFF
Follow the system prompts, until read ECU procedure is processing
Save the ECU reading result to “e90 txt”
Update and Installation kess v2
Turn ignition OFF
Reading ECU completed

5) Program ECU with kess v2

Back to main program, click Help
Select Standard OBD cable, press View to check which cable you are going to connect with kess v2.
Select correct ECU type, like: Bosch EDC17 ECUs
Read the instruction carefully and follow the instruction to program ECU.
Update and Installation kess v2

How to Solve KESS V2 V2.13 firmware V4.036 Wake up error

OBDII365