How to replace 99% US cars’ Tire Pressure Sensor with Autel MX-Sensor

Obdii365 has newly launched Autel MX-Sensor 433MHz/315MHz universal programmable TPMS sensor specially built for Tire Pressure Sensor replacement. MX-Sensor covers 99% of the US and Canadian vehicles. Here we carry out a subject about the MX-Sensor.

Project Name:
How-to: replace 99% US cars’ Tire Pressure Sensor with Autel MX-Sensor

Project Description:
Learn the installation procedure of Autel MX-Sensor Tire Pressure Monitoring System (TPMS) sensors Autel MaxiTPMS TS401

Skill Level:
Easy

Project vehicle:
99% US and Canadian vehicles (433MHz/315MHz)

Tools Needed:
Bead loosener
Screwdriver
TPMS sensors
Tire tool
cars' Tire Pressure Sensor with Autel MX-Sensor
Project Time:
1 hour or less

Project Cost:
Cost of TPM sensors. (Autel MX SENSOR:US$23.99)
cars' Tire Pressure Sensor with Autel MX-Sensor

Install Sensors:

1) Loosening the tire
Remove the value cap and core and deflate the tire. Use the bead looserner to unseat the tire bead. Clean the valve stem hole with a Lint free cloth to ensure there is nothing that will compromise the seal between the valve stem the wheel. Also clean the back side of the wheel.
cars' Tire Pressure Sensor with Autel MX-Sensor
2) Dismount the tire
Clamp the tire onto the tire charger, and adjust the value at 1o’clock relative to the tire separation head. Insert the tire tool and lift the tire bead onto the mounting head to dismount the bead.
cars' Tire Pressure Sensor with Autel MX-Sensor

3) Dismount the sensor
Remove the fastening screw and sensor from value stem with a screwdriver. Then loosen the nut and remove the value.
cars' Tire Pressure Sensor with Autel MX-Sensor

4) Mounting sensor and value
Slide the value stem through the value hole of the rim. Tighten the screw-nut with 4.0 Nm with the help of the positioning pin. Assemble the sensor and value stem together by screw. Hold the sensor body against the rim and tighten the screw.
cars' Tire Pressure Sensor with Autel MX-Sensor

5) Mounting the tire
Place the tire on the rim, making sure that the value faces the separation head at an angle of 180%. Mount the tire over the rim.
cars' Tire Pressure Sensor with Autel MX-Sensor

6) Matching TPMS sensor

The sensors are matched to the tire/wheel positions in the following order: driver side front tire, passenger side front tire, passenger side rear tire, and driver side rear tire using a TPMS diagnostic tool. See your dealer/retailer for service.

OBDII365