VXDIAG VCX SE is a perfectly J2534 passthru for OEM diagnostic software (ODIS, Techstream, IDS, Xentry, ISTA, GDS2 etc) as well as pcmflash. Obdii365.com engineer has tested it working with the new pcmtuner usb dongle containing pcmflash with 67 modules. … Continue Reading
If pcmtuner dongle is hot, it is normal because it is LED. To get rid of the dongle hot issue, you can remove a chip on the dongle. * The new dongle manufactured after June 8th, 2022 has removed… Continue Reading
Is there any difference between green vs red usb dongle of pcmtuner? The red dongle is linked to pcmtuner hardware. The green dongle is purchased alone. Both can be used with most pass thru hardware like tactrix or scanmatik.… Continue Reading
New ECUHelp ECU Bench Tool any thoughts? What’s the difference between PCMTuner and ECU Bench Tool? Check table comparison below: Item PCMTuner ECUHelp ECU Bench Tool Image Dongle With a Smart USB dongle No dongle Software 1.Pcmtuner 2. Pcm flash… Continue Reading
As titled, can we use the PCMtuner smart usb dongle with original tatrix openport 2.0? Yes, the usb dongle can be used with any j2534 openport interfaces. The dongle is working with the original openport without issue. The dongle… Continue Reading
Problem: Received my PCMtuner, is it normal that the USB dongle those chip legs are not soldered to the board? Should I solder them or leave it? They are unused pads hence not soldered, IC has a large pad under so no need… Continue Reading
