Update Information and MQB car, cluster and chip type, check the previous post:
Make all connections to the dashboard.
this is a connection to the dashboard which is connected to the xp400.
there is your ground, positive, yellow and blue cables and there’s little lifted (lift pin method) or a little jumper wire
the white cable go to the chip, it is lifting the pin on the chip that can be hair raised.
You can also break the pin off of it with a little tiny copper wire.
you see it’s actually soldered directly to the pad or the chip
the connectors are all fairly simple. it is all well explained on the diagram where all the wires go. just be more careful
then connect apb130 with xp400 pro, could you add to 12v.
Read and save immo data
Once you read the data, it will give you an option to save the data.
Then let’s go to calculate immo data.
Select the MQB file just save and hit OK.
Save the new immo data.
Now you will see your CS code, and key information
The only thing miss is a PIN. This was a dashboard sourced from eBay so no ECU data is available for sync calculations.
if need to make a dealer key you need the ECU 32byte synchronization data which is what you’ll have to send off to 3rs party to get
That is the only way to get the deal to make a dealer key.