How-to: repair Honda airbag using CG100 Prog III airbag reset tool.
Power off vehicle
Remove and disassemble the airbag computer, check srs type and chip
In CG100 software, select Airbag function->Honda->77960-T9A-F411-M2
Check the wiring diagram, power on CG100 prog, connect CG-100 and airbag module following the wiring connection
Reading airbag data
Then save data
Save file successfully.
Remove collision fault code.
Note: Please do not touch any cables during repairing procedure.
Repairing Honda airbag in process until success
If CG100 prompts “Repair successfully” message, the repairing is done. Reinstall the airbag computer back on car and test it if it is ok.