This is the AT-200 ECU Programmer user manual, incl.
This is AT-200 programming software: 100% tested
Password: Not required
Security: Tested 100% with AT-200 programmer
This is the AT-200 software Windows 7 installation instruction.
Step 1: unzip the AT200 file
Open AT200 disk
Copy zip file “AT200 2019.4.5” to Desktop and unzip the file
Step 2: setup the usb device
Open Computer Management
Select: USB input device
Step 3: run AT-200 software and select a vehicle for programming
Open folder “AT200” on Desktop and run AT200 app
In the AT200 BMW car list
Note: AT200 programmer covers MSV90, MSVD85, MSVD85.1 ,MSVD85.2, MSVD87, MSVD87.2, N55, N20
Will cover B48, MB271,VAG W06J
This is an AT200 language setup tip.
AT200 languages: Chinese and English
How to: change AT200 Chinese into English
AT-200 programmer in Chinese
Select English as AT-200 programmer language
Steps to read ISN using AT-200:
Step 1: install and run AT-200 app
Step 2: connect the AT-200 with the DME and the laptop
Step 3: select the model
Step 4: read the wiring and check if the connection is correct or not
Step 5: AT-200 identifies the DME and then reads out the ISN
AT200 read out MSD85 ISN
AT200 read out MSD87 ISN
AT200 read out MSV90 ISN
AT-200 is verified to works good!
Time to use: less than 2 minutes for each test
Wiring diagrams are always available in AT-200 app, after you select a vehicle.
This is the full vehicle list of AT-200 BMW:
AT-200 programmer, Where to: http://www.obdii365.com/wholesale/bmw-at200-ecu-programmer.html