How to read VAG EDC16 using CarProg and A1+ adapter

How to: read 95320 eeprom from Vw Touran EDC16u34

 

Device: Carprog full

Adapter: carprog A1+ adapter

 

FAQs: How to use CarProg with EDC16 VAG

Q: Does CARPROG need external power supply ??
A: Carprog does not need external power supply for that eeprom.

 

Q: Can I read the memory in circuit or have to desolder ??
To read eeprom, always better to desolder.

 

Q: Does ECU need 12v??
A: No need 12v on ecu.

 

Q: Should I have a clip for 8 pin eeprom?

A: Yes i have a clip

 

Q: Did I locate pin1 correctly?

Carprog-8.21-eeprom-pins

A: Yes. Pin1 is correct. Try with the eeprom clip. The red wire of the flat cable should be on the pin 1. And desolder.

 

Q: I use Carprog 8.21 with A4 Adapter.

edc15 24c02 No problem, but with 95320 edc16 no success

Carprog-8.21-A4-Adapter

Wires connected like on the picture
WIRES

Carprog-8.21-wire

A: For EDC16 and VAG ECU software you must update A1+:

download update file:

http://www.codecard.lt/images/file/A1_PLUS_update_EDC16_ADGwLRiHgSKyt7lIWAmzimNN.zip

Unzip file to your computer, connect CarProg programmer with A1+ adapter to OBDII connector and make A1+ update.

 

Note: Carprog A1 vs A1+ adapter

 

A1+ (A1 PLUS) – new generation ODB2 adapter CarProg use for Volvo dashboard programming and VAG ECU programming.
A1 is not the same adapter like A1+. And A1+ not replace old A1. These are 2 different adapters.

A1+ (A1 PLUS) is a new OBDII adapter with high speed CAN.

src: http://www.obdii365.com/wholesale/a1-cable-for-carprog-full-v4-01.html

a1+-cable-for-carprog

Then your Carprog will work with VW, Audi, Seat, Skoda EDC15, EDC16 ECU:

  • EDC16U1 – read memory, read/write odometer, read immobiliser data: VIN, PIN, CS( component security), MAC;
  • EDC16U34 – read memory, read/write odometer, read immobiliser data: VIN, PIN, CS( component security), MAC;
  • EDC16U31 – read memory, read/write odometer, read immobiliser data: VIN, PIN, CS( component security), MAC;
  • EDC16CP – read memory, read/write odometer, read immobiliser data: VIN, PIN, CS( component security), MAC;
  • 1 – read immobiliser data: VIN, PIN, CS( component security), MAC;
  • 5.10 – read immobiliser data: VIN, PIN, CS( component security), MAC;
  • EDC15 – read/write EEPROM memory, read/write odometer, read immobiliser data: VIN, PIN;
  • ME7 – read immobiliser data: VIN, PIN;

 

Carprog full is reading VAG EDC16…

carprog-edc16-read-1

carprog-edc16-read-2

http://www.obdii365.com/producttags/carprog.html

 

OBDII365