Here is a step-by-step tutorial on how to use V2.13 KTAG V6.070 ECU Programmer reading Opel Insignia ECU EDC17 C59 in EEPROM TC1767.
Purpose:
To read opel insignia EDC17 C59 in a cheap way
First, you need the main unit—ktag ksuite V2.13 ECU master , $79 at obdii365.com here:
http://www.obdii365.com/wholesale/ktag-ecu-programming-with-new-hardware.html
Material needed:
Cable 14P600KT02
16-way rainbow ribbon cable 144300T105
Two 470 Ohm resistors
Solder wires
You can start reading Opel Insignia ECU now!
Take apart the ECU from vehicle, open the ECU unit and connect ECU with KTAG
If you don’t know how to connect to ECU, you can choose “Plug-in 688…” to check detailed connection instruction, or it may cause damage to ECU, good luck for you!
Select vehicle model and ECU: OPEL-> Insignia -> BOSCH EDC17C59
After reading the instruction in detail and solder wires, successfully connect to ECU with KTAG v6.070
Then click OK to continue
Select the plug-in 688
Click “Read”
Ktag is identifying ECU…wait for a while
Then it is reading EEPROM…the operation may take several minutes
KTAG ECU Programmer Reading ECU17C59 successfully! You can save the file to “OPEL-Insignia-2012-ECU17C59”
Finally, Remove the soldered wires and the resistors before re-installing the ECU to vehicle.
