How to change BMW VO Vehicle Order by Ncs Expert

Here is the step-by-step guide to change BMW VO (Vehicle Order) by using BMW Ncs expert coding software.

 

Instruction:

ncs-expert-change-vo-1

Before NCS Expert can be used a Profile must be loaded.

Select File/Load Profile from top menu bar

ncs-expert-change-vo-2

Select Expert Mode, then press OK

ncs-expert-change-vo-3

One a profile is loaded, the bottom buttons become selectable.

Select F1 to read vehicle data first

ncs-expert-change-vo-4

Select F3 to read FA from ECU.

This needs to be done before any coding can be performed.

ncs-expert-change-vo-5

Select the model you are working with.

For this example “E65″

Select OK once highlighted

ncs-expert-change-vo-6

Choose the ECU to read the Vehicle Order from. In this example “CAS”

Select OK

ncs-expert-change-vo-7

The Model,VIN and VO should then be displayed

Select F2 to modify VO

ncs-expert-change-vo-8

Select the mode you are working with, i.e “E65″

Select OK once highlighted

ncs-expert-change-vo-9

Verify that the VIN is correct

Note:latest digit is a checksum

Select OK

ncs-expert-change-vo-10

Enter SA or Service code,then select Add

Enter FA SA codes must begin with $

Service codes must begin with +

ncs-expert-change-vo-11

Example: Enter$655

Select “Add”

Scroll down to check

ncs-expert-change-vo-12

ncs-expert-change-vo-13

Example: Enter +EVER

Select “Add”

Scroll down to check

Select OK

ncs-expert-change-vo-14

After you have successfully changed the VO you will see this screen

Select F6 (Back)

ncs-expert-change-vo-15

Select F4 Process ECU

ncs-expert-change-vo-16

Select the CAS

ncs-expert-change-vo-17

Select F2 Change Job

ncs-expert-change-vo-18

Select “FA_WRITE”

ncs-expert-change-vo-20

Vehicle jobname is “FA_WRITE” and CAS is ECU selected

Select F3 Execute Job

ncs-expert-change-vo-21

Select F1 Change ECU to select LM

This will ensure that new VO is written into CAS and LM

ncs-expert-change-vo-22

Select “LMA”

ncs-expert-change-vo-23

Verify Jobname is “FA-WRITE” and LMA is ECU selected

Select F3 Execute Job

Done.

 

BMW ICOM A2+B+C with engineering software INPA, NCS Expert, WinKFP, E-sys etc

http://www.obdii365.com/wholesale/new-bmw-icom-a2-b-c-diagnostic-programming-tool.html

OBDII365