Received my ENET Ethernet to OBD cable yesterday and cannot wait for any moment that I used it to code my F20 this morning.
The ENET F-series coding cable came with e-sys 3.22 software but I didn’t use it. Searched forums for a newer software myself. Forum members said their E-sys 3.22 worked well.
Here are some setup i did.
Go to Expert Mode
Select coding, then connection
Open connection: TargetSelector: Project=F020_15_07_506, VehicleInfo=F020
Setup 1- Activate diagital speedo
Go to Editors & Viewers
Then FCL-Editor
Open file: [KOMBI]…
Search for: bc_digi
Go to BC_DIGITAL_V->Ausgelesen
Edit nich_aktiv to aktiv
Save data
Setup 2- Deactivate code temperature warning
Search for: cc_temp
Go to CC_TEMPERATUREWARNING->Ausgelesen
Edit aktiv to nich_aktiv
Save data
Setup 3 – Deactivate the active sound generator
Open file: [HU_NBT]…
Search for: asd_sound
Go to ASD_SOUND_OFF->Ausgelesen
Edit nich_aktiv to aktiv
Save data
Setup 4 – Deactivate seatbelt reminder
Open file: [ACSM_4B]…
Search for: seatbeltre
Go to SeatbeltReminder_SBR_Fahrer->Ausgelesen
Edit aktiv to nich_aktiv
Save data
All I did today…Activate diagital speedo, Deactivate code temperature warning & the active sound generator & seatbelt reminder…
Referred to posts about coding instruction on forums to finish… Not
Lots of promotion of ENET (Ethernet to OBD) interface on webs but I don’t know what are the differences and quality… However, I am lucky to get a good one once. I read a DIY guide of BMW ENET cable.. Sounds not difficult.. Maybe I can have a try.
