How to do 08 Tundra zero point calibration with Toyota TIS techstream cable

How to calibrate 2008 Toyota Tundra steering angle sensor:

Equipment needs:
Toyota TIS Techstream OBDⅡdiagnostic cable (MINI VCI 16 Pin, MINI VCI 22 Pin, mangoose VCI, MVCI Techstream + JLR mangoose + Volvo Vida dice 3 in 1)

1. CALIBRATION
Perform the chart below to perform calibration. Performing “Front wheel alignment adjustment”, clear and read the sensor calibration data.

2. CLEAR ZERO CALIBRATION DATA WITH TECHSTREAM SOFTWARE

1) Connect the Toyota TIS Techstream OBD2 diagnostic cable with vehicle via OBD port
2) Turn ignition to ON position
3) Follow the Techstream prompts to clear the error codes (Select reset memory)
Toyota TIS techstream cable Toyota TIS techstream cable
3 PEFORM ZERO CALIBRATION

1) Enter Test Mode
Turn the ignition OFF
Check the shift level is in parking or natural and apply the parking brake
Connect the Techstream cable with vehicle via OBD port
Turn the ignition ON with engine off

2) Set the Techstream to Test Mode (Select Test Mode)

Obtain the zero points of the master cylinder pressure sensor and deceleration sensor.
Park the vehicle on stationary level surface for 1 second or more.
Check the buzzer sound for 3 sec and make sure the fault code is erased
Turn ignition to OFF position

4 CLEAR ZERO CALIBRATION DATA WITH SST CHECK WIRE

Turn ignition ON
Check the VSC OFF indicator light is illuminating
Operate the calibration by using a check wire

5. PERFORM ZERO CALIBRATION WITH SST WIRE
1) Enter Test Mode
Turn ignition to OFF position
Check the shift level is in parking or natural and apply the parking brake
Turn ignition ON with engine off

2) Obtain the zero points of the master cylinder pressure sensor and deceleration sensor.
Park the vehicle in stationary level surface for 1 second or more.
Check the buzzer sound for 3 sec and make sure the fault code is erased
Turn ignition to OFF position

6 INSTALL STEERING ANGLE SENSOR

Complete the adjustment of the steering wheel and wheel alignment, and then initialize the steering angle sensor. If the order is reversed, the steering wheel and wheel alignment will become misaligned.
(a) Check that the steering wheel is in the centered position.
(b) Disconnect the negative battery terminal for more than 2 seconds. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
(c) Reconnect the negative battery terminal

OBDII365