Here’s the instruction on adding Cummins Inline 5 data link truck diagnostic adapter to INSITE 8.2.0 software.
Preparation:
First you need to close all anti-virus software program
Then install Cummins 8.2.0 pro/lite version software
How to Install Activate Cummins Insite 8.2.0.184 Pro and Lite
Step 1: Install Inline 5 driver
Check your operating system, here we set it up on Windows 7 32-bit
Open software CD
Open INSITE.7_6_2.rar-> Software folder->INSITE 5 Drivers
Copy Inline 5.7.0.1 Setup- 32 Bit.exe to desktop
If you use 64-bit system, you copy Inline 5.7.0.1 Setup- 64 Bit.exe to desktop
Install the adapter driver, here we use Cummins Inline5 data link (you can use Inline 6, nexiq or other adapters as well)
Run Inline 5.7.0.1 Setup-32 Bit on desktop as administrator
Click on NEXT
Accept the windows security warning to install driver software
Tick “Launch Inline 4/5 Reflash Tool” and click on Finish
Delete Inline 5.7.0.1 Setup-32 Bit on desktop
Device driver has been successfully installed
Open Computer->Manager->Device Manager->Universal Serial Bus Controller to check device is well connected
Step 2: Add Inline5 adapter to INSITE 8.2.0
Open INSITE 8.2.0.184 pro or lite version software on desktop
Select Add New option on the middle of the bottom tool bar
Click Next to install ECU Connection Wizard
Select RP1210 adapters, click on Next
Select Vendor, Adapter INLINR 5 USB and protocol Auto detect, click on Next
Click on Next
Tick both 2 options and click Finish
Again software will prompt to install ECU connection wizard, click next
Do the same setting as above, but this time we choose protocol J1708
Click Finish
Do the setting again, this time we add protocol J1939
Click Finish and cancel ECU connection wizard interface
Please add the corresponding adapter in the iniste software
Select INLINES USB (Auto Detect) Connection on the middle of bottom tool bar
Click Connect button to connect to ECM
Now you can using the software, read fault code, manage data logger, do calibration etc